LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Cobalt SS >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 2.0L - (Introduction) >> Repair Instructions >> Filler Tube Replacement >> Installation Procedure

Installation Procedure

  1. Install the fuel filler pipe assembly into position on the vehicle.
  2. Connect the fuel filler hose to the fuel tank.
    3. Fig 1: Locating Fuel Filler Pipe Assembly Lower Retaining Bolt
    GM879143Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the fuel filler pipe assembly lower retaining bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    4. Fig 2: Fuel Filler Pipe Jumper Hose
    GM889977Courtesy of GENERAL MOTORS CORP.
  4. Tighten the fuel filler hose clamp (1) at the fuel tank.

    Tighten:  Tighten the clamp to 4.5 N.m (40 lb in).

    5. Fig 3: View Of EVAP Pipes
    GM889726Courtesy of GENERAL MOTORS CORP.
  5. Connect the EVAP vent pipe (1) to the EVAP canister. Refer to CELL LINK 16239.
  6. Lower the vehicle.
    7. Fig 4: Locating Fuel Filler Pipe Assembly Upper Retaining Bolt
    GM879144Courtesy of GENERAL MOTORS CORP.
  7. Install the fuel filler pipe assembly upper retaining bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  8. Install the fuel filler pocket. Refer to Fuel Filler Pocket Replacement in Body Rear End.
  9. Refill the fuel tank.
  10. Install the fuel fill cap.
scientia non olet · About LEMON Manuals