LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Cobalt SS >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 2.0L - (Introduction) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Removal Procedure

Removal Procedure

  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  2. Remove the underhood junction block. Refer to Underhood Electrical Center or Junction Block Bracket Replacement in Wiring Systems.
  3. Disconnect the electrical connector from the camshaft position (CMP) sensor.
    4. Fig 1: View Of Camshaft Position Sensor Housing
    GM1534962Courtesy of GENERAL MOTORS CORP.
  4. Remove the CMP sensor studs.
  5. Remove the CMP sensor.
scientia non olet · About LEMON Manuals