LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Cobalt SS >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 2.0L - (Introduction) >> Repair Instructions >> Barometric Pressure (BARO) Sensor Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Locating SCIP Sensor & BARO Sensor
    GM1389393Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the barometric pressure (BARO) sensor harness connector.
  2. Remove the BARO sensor bracket and bolt.
  3. Remove the BARO sensor (2).
scientia non olet · About LEMON Manuals