LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Cobalt SS >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 2.0L - (Introduction) >> Repair Instructions >> Barometric Pressure (BARO) Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Locating SCIP Sensor & BARO Sensor
    GM1389393Courtesy of GENERAL MOTORS CORP.
  1. Install the BARO sensor (2).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the BARO sensor bracket and bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  3. Connect the BARO sensor harness connector.
scientia non olet · About LEMON Manuals