Removal Procedure
- Disable the SIR System. Refer to SIR Disabling and Enabling Zone 3 .
- Remove the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement .
- Remove the steering wheel nut.
- Note the mark on the steering shaft and the steering wheel to ensure proper alignment during installation.
- Remove the steering wheel from the steering shaft. Refer to Steering Wheel Replacement in Steering Wheel and Column.
- Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement in Steering Wheel and Column.
- Remove the wire harness straps from the steering wheel column wire harness.
- Remove the instrument panel carrier. Refer to Instrument Panel (I/P) Carrier Replacement in Instrument Panel, Gages, and Console.
- Disconnect the SIR harness from the back of the fuse panel.
- Remove the retaining ring (3).
- Remove the SIR coil (4) from the steering shaft.
- If replacing, discard the SIR coil.
CAUTION:
Refer to SIR Caution
in Cautions and Notices.