Scan Tool Data Definitions
- Accessory Switch
-
Input from ignition switch Accessory circuit. Used to determine power mode. Hot in ACC and ON.
- Battery Voltage
-
The scan tool displays 0.0-16.0 volts. The battery voltage input represents the system voltage measured at the BCM ignition feed input.
- Cargo Door Ajar Switch
-
Input from the cargo door showing the state of it.
- Driver/Passenger Door Ajar Sw.
-
Input from the respecting door indicating door status.
- GM Part Number
-
The module's part number.
- Ignition Unlock
-
Input to the control module from the ignition switch indicating the Ignition 0 position. Switch closed (HOT) in ignition switch positions UNLOCK, ACC, ON, and START.
- Run/Crank
-
Input to the control module from the ignition switch indicating the Ignition 1 position. Switch closed (HOT) in ignition switch positions ON and START.
- Key in Ignition
-
Input from ignition switch indicating that the ignition key is inserted into the ignition switch. HOT with key in ignition switch.
- Julian Date of Build
-
The day of the year when module was built.
- RAP Relay
-
Output indicating the state of the RAP relay. It is On for all power modes except Off Awake.
- Year Module Built
-
The year when module was built.