LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Blazer 2D Utility, RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Entertainment System) >> Repair Instructions >> Power Antenna Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 GMC Safari and 2005 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Power Antenna Cable View
    GM296687Courtesy of GENERAL MOTORS CORP.
  1. Snap the bezel into the rear quarter panel in order to install the antenna bezel.
  2. Install the power antenna.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the power antenna bracket bolt (2).

    Tighten:  Tighten the power antenna bracket bolt to 5 N.m (44 lb in).

  4. Install the drain tube (1) to the grommet in the rear quarter panel.
  5. Connect the power antenna electrical connector (3).
  6. Connect the antenna cable (4) to the power antenna.
  7. Install the jack and the spare tire.
  8. Install the quarter inner rear trim finishing panel.
scientia non olet · About LEMON Manuals