Installation Procedure

WARNING: This page is about a different car, the 2005 GMC Sierra and 2005 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Wiper Motor

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the wiper motor onto the wiper transmission assembly with the 2 bolts.
Tighten: Tighten the 2 bolts to 8 N.m (71 lb in).

Fig 2: Installing Wiper Transmission To Wiper Motor Crank Arm

Courtesy of GENERAL MOTORS CORP.

Install the drive link onto the wiper motor crank arm with the J 39529 . See Special Tools .

Fig 3: Wiper Transmission Assembly

Courtesy of GENERAL MOTORS CORP.

Install the wiper transmission assembly on the vehicle with the 2 bolts.
Tighten: Tighten the 2 bolts to 9 N.m (80 lb in).

Fig 4: Wiper Motor Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connector to the wiper motor.

Fig 5: Reinforcement Panel Bolts

Courtesy of GENERAL MOTORS CORP.

Install the reinforcement panel with the 4 bolts.
Tighten: Tighten the 4 bolts to 9 N.m (80 lb in).
Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
Install the wiper arms. Refer to Wiper Arm Replacement .
Operate the wipers and check for proper operation.