Starter Generator Control Module Cooling Fan Always On
WARNING: This page is about a different car, the 2005 GMC Sierra and 2005 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Starter Generator Control Module Cooling Fan Always On
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Engine Cooling Schematics Connector End View Reference: Cooling System Connector End Views DEFINITION: The HGCM coolant fan motor runs continuously. |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
| 2 | Turn ON the ignition, with the engine OFF. Is the engine coolant fan running all the time? |
Go to Step 3 | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems |
| 3 | Remove the coolant fan relay. Did the coolant fan turn OFF? |
Go to Step 5 | Go to Step 4 |
| 4 | Repair the short to power in the coolant fan motor supply voltage circuit. Refer to Wiring Repairs
in Wiring Systems. Did you complete the repair? |
Go to Step 7 | - |
| 5 | Inspect for poor connections at the coolant fan relay. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 7 | Go to Step 6 |
| 6 | Replace the coolant fan relay. Did you complete the repair? |
Go to Step 7 | - |
| 7 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |