Installation Procedure

WARNING: This page is about a different car, the 2005 GMC Sierra and 2005 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Install the hood hinge to the hood. Refer to Hood Hinge Replacement .

Fig 1: View Of Hood, Hinge & Bolts

Courtesy of GENERAL MOTORS CORP.

With an assistant, install the hood (1) to the vehicle.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the pivot bolt (3).
Tighten: Tighten the pivot bolt to 25 N.m (18 lb ft).
Lower the hood.

Fig 2: View Of Cowl Vent Grille Panel Outboard Section

Courtesy of GENERAL MOTORS CORP.

Install the outboard section of the cowl vent grille panel.
Raise the hood.

Fig 3: View Of Hood, Hinge & Bolts

Courtesy of GENERAL MOTORS CORP.

Install the bolt (7) holding the hinge to the link assembly.
Tighten: Tighten the hinge to link assembly bolt (5) to 25 N.m (18 lb ft).

Fig 4: Hood Ground Strap & Nut

Courtesy of GENERAL MOTORS CORP.

Install the hood ground strap and nut. Clip the hangers and the lamp in place.
Tighten: Tighten the ground strap nut to 9 N.m (80 lb in).
Lower the hood.