LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Avalanche 2500 >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Battery, Charging System And Starting System - Introduction) >> Repair Instructions >> Generator Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 GMC Sierra and 2005 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to BATTERY DISCONNECT CAUTION in Cautions and Notices.
    Fig 1: View Of Generator Cable & Nut
    GM395686Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery)  or Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) .
  2. If necessary, remove the engine sight shield. Refer to Engine Sight Shield Replacement (4.8L, 5.3L, and 6.0L (RPO LQ4)) or Engine Sight Shield Replacement (6.0L (RPO LQ9)) in Engine Mechanical - 4.8L, 5.3L, and 6.0L.
  3. Remove the generator cable from the generator, perform the following:
    1. Reposition the boot to expose the stud.
    2. Remove the generator cable nut.
    3. Remove the generator cable from the stud.
    4. Fig 2: View Of Battery Cables At Junction Block
    GM662521Courtesy of GENERAL MOTORS CORP.
  4. Open the positive cable junction block.
  5. Remove the generator cable nut.
  6. Remove the generator cable (2) from the junction block.
scientia non olet · About LEMON Manuals