LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Avalanche 2500 >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Engine Controls - 4.3L (Introduction)) >> Repair Instructions >> Throttle Position (TP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 GMC Sierra and 2005 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of TP Sensor, IAC Motor, ECT Sensor, Control Port Injector Module & Engine Harness Clip Bolt
    GM782174Courtesy of GENERAL MOTORS CORP.
  1. Remove the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .
  2. Disconnect the throttle position (TP) sensor electrical connector (1).
    3. Fig 2: View Of TP Sensor Screws
    GM10935Courtesy of GENERAL MOTORS CORP.
  3. Remove the TP sensor screws.
    4. Fig 3: View Of TP Sensor
    GM10936Courtesy of GENERAL MOTORS CORP.
    NOTE: The TP sensor is an electrical component. Do not soak the TP sensor in any liquid cleaner or solvent, as damage may result.
  4. Remove the TP sensor.
scientia non olet · About LEMON Manuals