Installation Procedure

WARNING: This page is about a different car, the 2005 GMC Sierra, 2005 GMC Cab & Chassis Sierra, 2005 Chevrolet Silverado, and 2005 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.

Fig 1: Locating Coolant Temperature Sensor

Courtesy of GENERAL MOTORS CORP.

If installing the old sensor, coat the threads with sealant GM P/N 12346004 (Canadian P/N 10953480), or equivalent.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the ECT sensor (1).
Tighten: Tighten the sensor to 20 N.m (15 lb ft).

Fig 2: View Of Engine Coolant Temperature Sensor And Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the ECT sensor electrical connector.
Fill the cooling system, if necessary. Refer to Draining and Filling Cooling System (w/RPO HP2) or Draining and Filling Cooling System (w/o RPO HP2) in Engine Cooling.