Installation Procedure

WARNING: This page is about a different car, the 2005 GMC Sierra and 2005 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Tool Storage Compartment Bracket (PRO)

Courtesy of GENERAL MOTORS CORP.

Install the brackets to the vehicle and hand tighten the nuts.
Install the tool storage compartment. Refer to Tool Storage Compartment Replacement (PRO) .

NOTE: Refer to Fastener Notice in Cautions and Notices.

Tighten the nuts that retain the tool storage compartment brackets (1), (2) to the seat riser studs.
Tighten: Tighten the nuts to 50 N.m (36 lb ft).
Install the rear seat hinge filler panel cover and plastic push pins.