Removal Procedure
WARNING: This page is about a different car, the 2005 GMC Sierra and 2005 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the right side junction block from the instrument panel (I/P). Refer to Instrument Panel Electrical Center or Junction Block Replacement - Right
in Wiring Systems.
Do not disconnect the electrical connectors.
- Lower the I/P compartment door to the full open position.
- From the junction block opening, remove the 2 retaining screws.
- Pull the receiver and bracket assembly from the I/P compartment opening.
- Disconnect the wire connector (1).
- Disconnect the coaxial cables from the receiver.
- Remove the receiver and bracket assembly from the I/P.
IMPORTANT:
Do NOT swap digital radio receivers between vehicles. Swapping digital receivers between vehicles will activate the digital radio Theftlock®, and "XM Theftlock®" will display.