LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Avalanche 2500 >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Entertainment System) >> Repair Instructions >> Microphone Replacement - Radio Volume Compensator Interior >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 GMC Sierra and 2005 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Screws (1) That Retain The Radio Volume Compensator Microphone (2) To The Floor Console Trim Panel
    GM1376879Courtesy of GENERAL MOTORS CORP.
  1. Install the radio volume compensator microphone (2) to the floor console side trim panel.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the radio volume compensator microphone screws (1).

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  3. Align the side trim panel to the floor console and connect the radio volume compensator microphone (2) electrical connector.
  4. Install the electrical connector hold down clip to the floor console.
  5. Align the trim panel to the floor console, push the panel towards the floor console to engage the panel clips.
    6. Fig 2: Locating Console Side Panel Screw
    GM1207752Courtesy of GENERAL MOTORS CORP.
  6. Install the front console side panel screw (1).

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

    7. Fig 3: View Of Seat Track Trim & Rear Console Side Panel Screw
    GM1207757Courtesy of GENERAL MOTORS CORP.
  7. Move the front seat fully forward.
  8. Install the rear console side panel screw (2).

    Tighten:  Tighten the retaining screw to 2 N.m (18 lb in).

  9. Reposition the inboard seat track trim (1).
  10. Install the floor console storage bin. Refer to Console Storage Bin Replacement (Expect Pro) or Console Storage Bin Replacement (Pro) in Instrument Panel, Gages and Console.
  11. Install the floor console end panel. Refer to Center Console End Panel Replacement in Instrument Panel, Gages and Console.
  12. Install the floor console cupholder. Refer to Cupholder Replacement (Luxury) or Cupholder Replacement (Non-Luxury) or Cupholder Replacement (Rear) or Cupholder Replacement (Pro) in Instrument Panel, Gages and Console.
  13. Install the floor console bezel. Refer to Bezel Replacement - Floor Console (Non-Luxury Upper) or Bezel Replacement - Floor Console (Luxury Upper) or Bezel Replacement - Floor Console (Non-Luxury Lower) in Instrument Panel, Gages and Console.
scientia non olet · About LEMON Manuals