LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Astro Van Cargo, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - (Introduction) Specifications & Repair Instructions >> Repair Instructions >> Knock Sensor (KS) Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Locating Knock Sensor & Retaining Bolt
    GM679284Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Component Fastener Tightening Notice in Cautions and Notices.
  1. Install the knock sensor (2) and the knock sensor bolt (1).

    Tighten:  Tighten the sensor to 25 N.m (18 lb ft).

  2. Connect the knock sensor harness connector (3).
  3. Install the engine cover. Refer to Engine Cover Replacement in Interior Trim.
  4. Connect the negative battery cable.
scientia non olet · About LEMON Manuals