LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Venture LT, FWD >> Repair and Diagnosis >> Steering >> Steering Wheel & Steering Column >> Repair Instructions >> Ignition Lock Cylinder Case Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Locating Pan Head Tapping Screws
    GM306295Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the ignition lock cylinder case assembly (1) and secure by using 3 pan head tapping screws (2).

    Tighten:  Tighten the screws to 7 N.m (62 lb in).

    2. Fig 2: Identifying Park Lock Cable At Ignition Lock Cylinder
    GM324874Courtesy of GENERAL MOTORS CORP.
  2. Connect the park lock cable assembly (1).
    • The lock cylinder should be in the OFF-LOCK position.
    • Install the locking tab at the end of the park lock cable assembly (1) into the ignition lock cylinder case assembly.
  3. Install the ignition switch assembly. Refer to Ignition Switch Replacement .
  4. Install the turn signal cancel cam. Refer to Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement .
  5. Install the steering column into the vehicle. Refer to Steering Wheel Replacement .
  6. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
scientia non olet · About LEMON Manuals