Removal Procedure

CAUTION: If a window is cracked but still intact, crisscross the window with masking tape in order to reduce the risk of damage or personal injury.

IMPORTANT: Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and inner trim.

Open the liftgate.
Remove the liftgate trim panel. Refer to Trim Panel Replacement - Liftgate in Body Rear End.
Remove the rear wiper motor. Refer to Wiper Motor Replacement - Rear in Wipers/Washer Systems.
Disconnect the rear window defogger connector.

CAUTION: If broken glass falls into the defroster outlets, it can be blown into the passenger compartment and cause personal injury.

Cover the following parts to protect from broken glass:
1. The upper dash pad
2. The defroster outlets and A/C outlets
3. The seats and carpeting

Fig 1: Separating Urethane Adhesive From Window

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Glass and Sheet Metal Handling Caution in Cautions and Notices.

IMPORTANT: Keep the cutting edge of the tool against the window.

Separate the urethane adhesive from the window.
- Leave a base of urethane on the pinchweld flange.
- The only suitable lubrication is clear water.
- Use J 24402-A . See Special Tools and Equipment .J 39032 or equivalent in order to remove the window. See Special Tools and Equipment .

Fig 2: View Of Liftgate Window

Courtesy of GENERAL MOTORS CORP.

With the aid of an assistant, use the suction cups in order to lift the liftgate window (2) from the opening.