LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Venture Base, Van Cargo Extended >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Theft Deterrent System >> Repair Instructions >> Theft Deterrent Control Module Replacement >> Installation Procedure

Installation Procedure

  1. Install the theft deterrent control module to the vehicle.
  2. Install the electrical connector and wires to the column.
    3. Fig 1: View Of Theft Deterrent Control Module
    GM473414Courtesy of GENERAL MOTORS CORP.
  3. Slide the theft deterrent control module over the ignition lock cylinder housing.
  4. Connect the electrical connector at the base to the steering column.
  5. Install the trim cover to the upper steering column. Refer to Steering Column Trim Covers Replacement in Steering Wheel and Column.
  6. Install the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement (Cylinder Rotates) or Ignition Lock Cylinder Replacement (Unable to Rotate Cylinder) in Steering Wheel and Column.
  7. Install the I/P knee bolster. Refer to Knee Bolster Replacement in Instrument Panel, Gages and Console.
  8. Program the theft deterrent system. Refer to Programming Theft Deterrent System Components .
scientia non olet · About LEMON Manuals