LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Tracker 4WD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Inflatable Restraint System >> Repair Instructions >> Inflatable Restraint Sensing and Diagnostic Module Replacement >> Removal Procedure

Removal Procedure

    CAUTION: Do not strike or jolt the inflatable restraint sensing and diagnostic module (SDM). Before applying power to the SDM, make sure that it is securely fastened with the arrow facing toward the front of the vehicle. Failure to observe the correct installation procedure could cause SIR deployment, personal injury, or unnecessary SIR system repairs.
    CAUTION: If the vehicle interior is exposed to moisture and becomes soaked up to the level of the sensing and diagnostic module (SDM), the SDM and SDM harness connector must be replaced. The SDM could be activated when powered, which could cause airbag deployment and result in personal injury.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 8 .
  2. Remove the rear console and then remove the front console in order to access the SDM (1). Refer to Console Replacement - Front Floor or to Console Replacement - Rear Floor in Instrument Panel, Gages and Console.
    3. Fig 1: View Of SDM
    GM190701Courtesy of GENERAL MOTORS CORP.
  3. Remove the Connector Position Assurance (CPA) and remove the electrical connector (6).
  4. Remove the SDM fasteners (1,2).
  5. Remove the SDM (5) from the vehicle.
    6. Fig 2: View Of CPA, Electrical Connector, Fasteners & SDM
    GM157011Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals