LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Tracker 4WD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 2.5L (LE8) (Introduction) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Removal Procedure

Removal Procedure

  1. Disconnect the electrical connector (1) from the camshaft position (CMP) sensor.
  2. Scribe an alignment mark on the flange of the CMP sensor housing and the cylinder head.
  3. Remove the CMP sensor housing bolts (3).
  4. Remove the CMP sensor (2) from the cylinder head.
    5. Fig 1: View Of Electrical Connector, CMP Sensor & Bolts
    GM677349Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals