LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Tracker 4WD >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Battery Negative Cable Replacement >> Installation Procedure

Installation Procedure

  1. Install the battery harness to the vehicle.
  2. Install the starter upper mounting bolt (1) and the ground wire.
  3. Install the battery positive wire to the starter (2). Secure with the nut.
  4. Install the battery positive wire to the generator. Secure with the nut.
  5. Install the harness clamp to the right engine mount. Secure with the bolt.
  6. Install the battery positive wires to the fuse box noting the correct terminal routing.
    7. Fig 1: Locating Starter Motor
    GM488766Courtesy of GENERAL MOTORS CORP.
  7. Install the fuse box (1) to the right inner fender. Secure with the 3 bolts.
    8. Fig 2: Identifying Relay Locations
    GM467821Courtesy of GENERAL MOTORS CORP.
  8. Install the ground wire to the bulkhead.
  9. Connect the harness (1) retainers.
  10. Install the positive battery cable to the positive battery terminal.
    11. NOTE: Refer to Fastener Notice in Cautions and Notices.
  11. Install the negative battery cable to the negative battery terminal.

    Tighten:  Tighten the battery cable-to-battery terminals to 15 N.m (11 lb ft).

    12. Fig 3: View Of Harness
    GM572671Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals