Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet SSR. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Amplifier Electrical Connectors & Fasteners

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Connect the electrical connectors (3) to the amplifier.
Install the 4 fasteners (1, 2) that hold the amplifier to the bin.
Tighten: Tighten the fasteners to 9 N.m (80 lb in).

Fig 2: View of Intermediate Bracket Fasteners

Courtesy of GENERAL MOTORS CORP.

Install the 4 fasteners retaining the intermediate bracket.
Tighten: Tighten the fasteners to 2 N.m (18 lb in).
Install the folding top control module. Refer to Folding Top Control Module Replacement in Roof.
Install the rear relay center. Refer to Rear Electrical Center or Junction Block Replacement in Wiring Systems.
Install the DRL diode. Refer to Daytime Running Lamps (DRL) Diode Replacement in Lighting Systems.

Fig 3: Identifying Body Accessory Compartment Lid Nuts

Courtesy of GENERAL MOTORS CORP.

Install the lid to the body accessory compartment.
Tighten: Tighten the nuts to 7 N.m (62 lb in).
Close the folding top.