LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> SSR >> Repair and Diagnosis >> External Pages >> Different car >> Section 686 (Engine Control System - 5.3L - Introduction) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Chevrolet SSR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove intake manifold. Refer to Intake Manifold Replacement .
  2. Disconnect the electrical connector from the camshaft position (CMP) sensor.
    3. IMPORTANT: Clean the area around the CMP sensor before removal in order to prevent debris from entering the engine.
    Fig 1: View Of Camshaft Position (CMP) Sensor & Bolt
    GM260128Courtesy of GENERAL MOTORS CORP.
  3. Remove the CMP sensor retaining bolt.
  4. Remove the CMP sensor.
scientia non olet · About LEMON Manuals