Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet SSR. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View of Control Module

Courtesy of GENERAL MOTORS CORP.

Install the folding top control module into the vehicle.

Fig 2: Identifying Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connectors to the control module.

Fig 3: View of Control Module Clips

Courtesy of GENERAL MOTORS CORP.

Push down firmly on the control module to seat the folding top control module clip into the body rear compartment.

Fig 4: View of Body Rear Compartment Lid

Courtesy of GENERAL MOTORS CORP.

Install the body rear compartment lid.

Fig 5: Identifying Body Rear Compartment Lid Fasteners

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the body rear compartment lid fasteners.
Tighten: Tighten the body rear compartment lid fasteners to 2 N.m (18 lb in).

Fig 6: View of Body Rear Compartment Lid Latches

Courtesy of GENERAL MOTORS CORP.

Latch the body rear compartment lid latches.
Remove the protective coverings from the vehicle.
Connect the battery. Refer to BATTERY NEGATIVE CABLE DISCONNECT/CONNECT PROCEDURE .

IMPORTANT: The window cycle learn procedure must be performed or the folding top will not operate correctly.

Perform the window cycle learn procedure. Refer to Reinitialization of the Power Window in Doors.
Connect the Tech-2 and reset any diagnostic codes that may be present.
Cycle the folding top under power through one complete cycle in both directions.
Inspect the folding top for proper operation. Refer to Power Folding Top Description and Operation .