LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> SSR >> Repair and Diagnosis >> External Pages >> Different car >> Section 329 (Power Steering System) >> Repair Instructions >> Brake Pedal Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Once the Brake Pedal Position Sensor bolt is removed for any reason, a new 4 mm bolt, with fresh LOCTITE™ will need to be installed.
  1. Remove the brake pedal position sensor bolt (1).
    Fig 1: Brake Pedal Position Sensor Bolt
    GM1399581Courtesy of GENERAL MOTORS CORP.
  2. Remove the brake pedal position sensor (2) from the mounting bracket.
    Fig 2: Brake Pedal Position Sensor
    GM1399584Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the brake pedal position sensor electrical connector (1).
  4. Remove the brake pedal position sensor (2) from the vehicle
scientia non olet · About LEMON Manuals