LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> SSR >> Repair and Diagnosis >> Electrical >> Body Electrical >> Wiring Systems - Introduction >> Repair Instructions >> Rear Electrical Center or Junction Block Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Rear Electrical Center Retaining Tab
    GM1390816Courtesy of GENERAL MOTORS CORP.
  1. Position the rear electrical center near the mounting location.
  2. Connect the electrical connector to the rear electrical center.
  3. Install the rear electrical center to the intermediate bracket ensuring the retaining tab (1) is fully seated.
    4. Fig 2: View of Body Accessory Compartment
    GM1386454Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the lid to the body accessory compartment.

    Tighten:  Tighten the nuts to 7.0 N.m (62 lb in).

  5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  6. Close the folding top.
scientia non olet · About LEMON Manuals