Conditions for Running the DTC

DTCs P0106, P0107, P0108, P0117, P0118, P0122, P0123, P0317, P0336, P0337, P0341, P0342, and P0502 are not set.
The engine is operating for more than 10 seconds.
The camshaft position sensor is synchronized with the crankshaft.
The engine speed is between 600-6,500 RPM and steady.
The ignition 1 voltage is between 11-16 volts.
The engine coolant temperature (ECT) is between -7°C and +120°C (+19°F and +248°F).
The fuel level is more than 15 percent.
The throttle angle is steady within 3 percent.
The throttle angle is less than 3 percent when the vehicle speed is more than 10 km/h (6 mph)
The antilock brake system (ABS) and the traction control system (TCS), if equipped, is not active.
The torque management is not active.
The transmission is not changing gears.
The A/C clutch is not changing states.
The ECM is not in fuel shut-off or decel fuel cut-off mode.
The ECM is not receiving a rough road signal.
DTC P0300 runs continuously when the above conditions are met.