Circuit Description

The engine control module (ECM) controls most components with electronic switches which complete a ground circuit when turned ON. These switches are arranged in groups of 4 and 7, and they are called either a surface mounted quad driver module, which can independently control up to 4 output terminals, or an output driver module (ODM), which can independently control up to 7 outputs. Not all of the outputs are always used.

Drivers are fault protected. If a relay or solenoid is shorted, having very low or 0 resistance, or if the control side of the circuit is shorted to voltage, it would allow too much current flow into the ECM. The driver senses this and the output is either turned OFF or its internal resistance increases to limit current flow and protect the ECM and driver. The result is high output terminal voltage when it should be low. If the circuit from B+ to the component or the component is open, or the control side of the circuit is shorted to ground, terminal voltage will be low. Either of these conditions is considered to be a driver fault.

Drivers also have a fault line to indicate the presence of a current fault to the ECM central processor. A scan tool displays the status of the driver fault lines as 0=OK and 1=Fault.