LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Monte Carlo LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System 3.8L (Introduction)) >> Repair Instructions >> Air Cleaner Intake Duct Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the air cleaner intake duct to the throttle body.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the air cleaner intake duct to the air cleaner cover.

    Tighten:  Tighten the air cleaner duct clamp to 2 N.m (18 lb in).

  3. Install the IAT sensor.
  4. Connect the IAT sensor electrical connector (3).
    5. Fig 1: Connecting IAT Sensor Electrical Connector
    GM760425Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals