LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Malibu Maxx >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (Introduction) - 3.5L (Lx9) >> Repair Instructions >> Throttle Body Assembly Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Installing Throttle Body Assembly
    GM1239002Courtesy of GENERAL MOTORS CORP.
  1. Install a new gasket, if necessary.
  2. Install the throttle body assembly.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the throttle body nuts and the bolts.

    Tighten:  Tighten the nuts and the bolts to 10 N.m (89 lb in).

    4. Fig 2: Installing Heater Pipe Nut To Throttle Body
    GM1239021Courtesy of GENERAL MOTORS CORP.
  4. Install the heater pipe nut to the throttle body.

    Tighten:  Tighten the nut to 25 N.m (18 lb ft).

  5. Connect the ETC electrical connector.
  6. Install the air cleaner intake duct. Refer to Air Cleaner Intake Duct Replacement .
scientia non olet · About LEMON Manuals