Installation Procedure

WARNING: This page is about a different car, the 2006 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Steering Rack

Courtesy of GENERAL MOTORS CORP.

Install the power steering gear heat shield.

NOTE: Refer to FASTENER NOTICE .

Install the power steering gear heat shield retaining bolts.
Tighten: Tighten the power steering gear heat shield retaining bolts to 9 N.m (80 lb in).
Install the plastic clip to the power steering gear heat shield.
Install the stabilizer shaft links. Refer to Stabilizer Shaft Link Replacement .
Lower the vehicle.