Removal Procedure

WARNING: This page is about a different car, the 2010 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Engine Wiring Harness Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
Disconnect the engine wiring harness electrical connector (1) from the manifold absolute pressure (MAP) sensor.

Fig 2: View Of Left Side Spark Plug Wires

Courtesy of GENERAL MOTORS CORP.

Remove the spark plug wire clip from the MAP sensor bracket, if necessary.

Fig 3: View Of Upper Intake Manifold

Courtesy of GENERAL MOTORS CORP.

Remove the upper intake manifold bolt.
Remove the MAP sensor bracket (5).
Remove the MAP sensor (6) and seal from the upper intake manifold. Discard the seal.