LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different car >> Section 450 (Wheel Alignment System) >> Repair Instructions >> Rear Camber Adjustment

Rear Camber Adjustment

WARNING: This page is about a different car, the 2007 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Inner Lower Control Arm Cam Bolt Nuts
    GM1237902Courtesy of GENERAL MOTORS CORP.
  1. Loosen the inner lower control arm cam bolt nuts.
  2. Rotate the cam bolts to the required camber specification setting. Refer to Measuring Wheel Alignment .
    NOTE: Refer to Fastener Notice .
  3. Maintain the camber setting while tightening the cam bolt nuts.

    Tighten:  Tighten the inner lower control arm (front) bolt nut to 110 N.m (81 lb ft).

    IMPORTANT: Check the toe setting AFTER changing camber or caster.
  4. Check the camber setting after tightening.
  5. Adjust the camber setting if necessary.
scientia non olet · About LEMON Manuals