Installation Procedure

WARNING: This page is about a different car, the 2012 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Crankshaft Position (CKP) Sensor

Courtesy of GENERAL MOTORS COMPANY

Install the crankshaft position sensor.

CAUTION:

Refer to Fastener Caution .

Install the crankshaft position sensor bolt and tighten to 10 N.m (89 lb in).

Fig 2: Identifying CKP Sensor & Knock Sensor

Courtesy of GENERAL MOTORS COMPANY

Connect the engine wiring harness electrical connector (2) to the CKP sensor.
Install the exhaust manifold lower heat shield. Refer to Exhaust Manifold Lower Heat Shield Replacement (LY7) .
Perform the Crankshaft Position System Variation Learn procedure. Refer to Crankshaft Position System Variation Learn .