LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Impala SS >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Body Front End >> Repair Instructions >> Hood Latch Support Replacement >> Installation Procedure

Installation Procedure

  1. Install the hood latch support to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: Installing Hood Latch Support Bolts
    GM456736Courtesy of GENERAL MOTORS CORP.
  2. Install the hood latch support bolts to the upper tie bar.

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

  3. Install the hood latch support nut to the lower tie bar.

    Tighten:  Tighten the nut to 10 N.m (89 lb in).

    Fig 2: Installing Hood Latch Support Nut
    GM456737Courtesy of GENERAL MOTORS CORP.
  4. Install the bolts to the upper support bracket at the front bumper fascia. Refer to Fascia Support Replacement - Front Bumper Upper (Impala) or Fascia Support Replacement - Front Bumper Upper (Monte Carlo) in Bumpers.
  5. Install the hood latch to the hood latch support. Refer to Hood Latch Replacement .
  6. Install the upper radiator air baffle. Refer to Radiator Air Baffle and Deflector Replacement - Upper in Engine Cooling.
  7. Close the hood.
scientia non olet · About LEMON Manuals