LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Impala SS >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System & Washer System >> Repair Instructions >> Wiper Drive System Module Replacement >> Installation Procedure

Installation Procedure

  1. Position the wiper drive system module to the vehicle.
  2. Connect the wiper motor electrical connector.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the wiper drive system screws.

    Tighten:  Tighten the screws to 10 N.m (89 lb in).

    4. Fig 1: Wiper Drive System Module & Screws
    GM815220Courtesy of GENERAL MOTORS CORP.
  4. Using the J 39529  (see Special Tools ), Install the wiper transmission to the wiper motor crank arm.
  5. Install the wiper motor water deflector. Refer to Wiper Motor Water Deflector Replacement .
  6. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
  7. Inspect the wipers for proper operation.
scientia non olet · About LEMON Manuals