LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Impala Police >> Repair and Diagnosis >> External Pages >> Different car >> Section 1116 (Front Suspension System) >> Repair Instructions >> Strut Assembly Removal and Installation >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2012 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Upper Strut Nuts
    GM2010688Courtesy of GENERAL MOTORS COMPANY
  1. Install the front strut assembly (2).
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the upper strut nuts (1) and tighten to 25 N.m (18 lb ft).
    3. Fig 2: Identifying Front Strut, Knuckle & Bolts
    GM2010684Courtesy of GENERAL MOTORS COMPANY
  3. Insert the front strut (6) in the knuckle (4).
  4. Install the strut bolts (5).
  5. Install the wheel speed sensor bracket (1).
  6. Install the front strut nuts (2) on the bolts (5) and tighten to 120 N.m (89 lb ft).
    7. Fig 3: Wheel Speed Sensor Electrical Connector
    GM1919656Courtesy of GENERAL MOTORS COMPANY
  7. Reconnect the wheel speed sensor electrical connector at the wheel speed sensor bracket, if equipped.
  8. Install the stabilizer shaft link (3). Refer to Stabilizer Shaft Link Replacement 
  9. Remove the support from the lower control arm.
  10. Install the front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  11. Lower the vehicle.
  12. Check the front end alignment specifications. Refer to Wheel Alignment Specifications .
scientia non olet · About LEMON Manuals