LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Impala Police >> Repair and Diagnosis >> External Pages >> Different car >> Section 1116 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2012 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE:

    Install the insulators so that the slit in the insulator is facing the rear of the vehicle.

  1. Install the insulators on the stabilizer shaft.
    2. Fig 1: Identifying Frame Support To Body Bolts
    GM1229967Courtesy of GENERAL MOTORS COMPANY
  2. Position the stabilizer shaft to the frame.
  3. Install the stabilizer bar clamps.
    4. CAUTION:

    Refer to Fastener Caution .

  4. Install the stabilizer shaft clamp bolts and tighten to 25 N.m (18 lb ft).
  5. Raise the rear of the cradle and install the cradle bolts. Refer to Frame Replacement (2.4L) , Frame Replacement (3.6L) .
  6. Remove the jack stand.
  7. Connect the stabilizer link to the stabilizer bar. Refer to Stabilizer Shaft Link Replacement .
  8. For vehicles equipped with the 3.6L LY7, install the exhaust pipe. Refer to Exhaust Pipe Replacement (LE5 or LE9 With MH8) , Exhaust Pipe Replacement (LY7) .
  9. Install the front tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation .
  10. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals