LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Impala LS >> Repair and Diagnosis >> Suspension >> Front Suspension >> Front Suspension System >> Repair Instructions >> Wheel Bearing/Hub Replacement - Front >> Installation Procedure

Installation Procedure

  1. Install the wheel bearing/hub with the splash shield as noted during removal.
    2. CAUTION: These fasteners MUST be replaced with new fasteners anytime they become loose or are removed. Failure to replace these fasteners after they become loose or are removed may cause loss of vehicle control and personal injury.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install NEW wheel bearing/hub bolts.

    Tighten:  Tighten the NEW wheel bearing/hub bolts to 130 N.m (96 lb ft).

    3. Fig 1: View Of Wheel Bearing/Hub & Splash Shield
    GM357695Courtesy of GENERAL MOTORS CORP.
  3. Install the brake rotor and caliper. Refer toBrake Rotor Replacement - Front (RPO J65, JL9) in Disc Brakes.
  4. Install the front wheel drive shaft nut. Insert a drift on a flat bladed tool into caliper and rotor to prevent the rotor from turning.

    Tighten:  Tighten the front wheel drive shaft nut to 210 N.m (155 lb ft).

    5. IMPORTANT: Ensure that the connector clip engages the bracket properly.
  5. Install the wheel speed sensor electrical connector to the bracket, if equipped.
    6. Fig 2: Installing Wheel Speed Sensor Electrical Connector To Bracket
    GM477813Courtesy of GENERAL MOTORS CORP.
  6. Connect the wheel speed sensor electrical connector (2), if equipped.
    7. Fig 3: View Of Wheel Speed Sensor, Connector And Harness
    GM188809Courtesy of GENERAL MOTORS CORP.
  7. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals