Installation Procedure

WARNING: This page is about a different car, the 2008 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.

Remove the rubber plug from the brake hose bolt hole of the brake caliper.

Fig 1: Brake Hose To Caliper View

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Install NEW copper brake hose gaskets.

Assemble the brake hose bolt and the NEW copper brake hose gaskets to the brake hose.

NOTE: Refer to Fastener Notice .

Install the brake hose bolt to the brake caliper.
Tighten: Tighten the brake hose bolt to 40 N.m (30 lb ft).

Fig 2: Identifying Brake Hose Retainer

Courtesy of GENERAL MOTORS CORP.

NOTE: Make sure the brake hose is not twisted or kinked after installation. Damage to the hose could result.

Install the brake hose to the brake hose bracket.
Install the brake hose retainer to the brake hose.

Fig 3: Identifying Front Brake Hose & Brake Pipe Fittings - L36

Courtesy of GENERAL MOTORS CORP.

Remove the rubber cap or plug from the exposed brake pipe fitting end.
Install the brake pipe fitting to the brake hose.
Tighten: Tighten the brake pipe fitting to 15 N.m (11 lb ft).

Fig 4: Locating Brake Hose Retainer Bolt

Courtesy of GENERAL MOTORS CORP.

Install the hose bracket and bolt to the strut assembly.
Tighten: Tighten the bolt to 17 N.m (13 lb ft).
Bleed the brake caliper at the brake caliper bleeder screw. Refer to Hydraulic Brake System Bleeding (Manual) or Hydraulic Brake System Bleeding (Pressure) .
Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
Lower the vehicle.