LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Impala LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 458 (HVAC System - Automatic) >> Repair Instructions >> Recirculation Actuator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the recirculation door actuator wire harness connector.
    2. Fig 1: Identifying Recirculation Actuator & Screws
    GM1203574Courtesy of GENERAL MOTORS CORP.
  2. Install the recirculation door actuator.
    3. NOTE: Refer to Fastener Notice .
  3. Tighten the recirculation door actuator screws.

    Tighten:  Tighten the screws to 1.5 N.m (13 lb in).

  4. Install the OnStar module bracket. Refer to Bracket Assembly Replacement - OnStar Module .
  5. Install the communication interface module. Refer to Communication Interface Module Replacement .
  6. Install the right closeout panel. Refer to Instrument Panel Insulator Panel Replacement - Right Side .
  7. Install the fuse labeled HVAC CTRL (BATT).
scientia non olet · About LEMON Manuals