Installation Procedure

WARNING: This page is about a different car, the 2006 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying CMP Sensor

Courtesy of GENERAL MOTORS CORP.

Lubricate the CMP sensor O-ring seal with clean engine oil.
Install the CMP sensor.

NOTE: Refer to Fastener Notice .

Install the CMP sensor bolt.
Tighten: Tighten the bolt to 10 N.m (89 lb in).

Fig 2: Identifying CMP Sensor Wiring Harness Connector

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connector (1) to the CMP sensor.