LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Impala LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 1090 (Wiper System And Washer System) >> Repair Instructions >> Windshield Washer Solvent Container Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2012 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the following components to the washer solvent container:
    2. Fig 1: Disconnecting Washer Level Sensor Electrical Connector
    GM1202069Courtesy of GENERAL MOTORS COMPANY
  2. Position the washer solvent container (4) to the left frame rail mounting studs.
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the washer solvent container nuts (3) and tighten to 10 N.m (89 lb in).
  4. Connect the washer pump electrical connector (2).
  5. Connect the washer level indicator electrical connector (1).
  6. Connect the washer pump hose to the pump spout.
  7. Engage the washer pump hose to the washer container.
  8. Install the front wheelhouse panel splash shield. Refer to Front Wheelhouse Panel Splash Shield Replacement .
  9. Lower the vehicle.
  10. Install the washer container filler tube. Refer to Windshield Washer Solvent Container Filler Tube Replacement .
  11. Fill the windshield washer container with clean windshield washer solvent.
  12. Inspect the washers for proper operation.
  13. Close the hood.
scientia non olet · About LEMON Manuals