LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Impala LS >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System 3.8L (Diagnostic Information & Procedures ) >> Diagnostic Information & Procedures >> Scan Tool Data List

Scan Tool Data List

The Engine Scan Tool Data List contains all engine related parameters that are available on the scan tool. The list is arranged in alphabetical order. A given parameter may appear in any one of the data lists, and in some cases may appear more than once, or in more than one data list in order to group certain related parameters together.

Use the Engine Scan Tool Data List only after the following is determined:

Scan tool values from a properly running engine may be used for comparison with the engine you are diagnosing. The Engine Scan Tool Data List represents values that would be seen on a normally running engine.

IMPORTANT: A scan tool that displays faulty data should not be used. The scan tool concern should be reported to the manufacturer. Use of a faulty scan tool can result in misdiagnosis and unnecessary parts replacement.

Only the parameters listed below are referenced in this service manual for use in diagnosis. If all values are within the typical range described below, refer to Symptoms for diagnosis.

The column labeled Data List indicates where a parameter can be located on the scan tool. Refer to the scan tool operating manual for the exact locations of the data lists. The following is a description of each term listed:

Eng 1

Engine Data 1 List

Eng 2

Engine Data 2 List

EGR

Exhaust Gas Recirculation Valve Data

EVAP

Evaporative Emissions Data

FUEL TRIM

Fuel Trim Data

Misfire

Cylinder Misfire Data

ODD

Output Driver Data

Scan Tool Data List

Scan Tool Parameter Data List Units Displayed Typical Data Value
Engine Idling/Radiator Hose Hot/Closed Throttle/Park or Neutral/Closed Loop/Accessories Off/Brake Pedal Released
3X Crank Sensor Eng 2 RPM Varies
18X Crank Sensor Eng 2 RPM Varies
1-2 Solenoid Circuit Status ODD OK/Fault/Invalid State OK
2-3 Solenoid Circuit Status ODD OK/Fault/Invalid State OK
A/C High Side Pressure Sensor Eng 2 psi/kPa/Volts Varies
A/C Off For WOT Eng 2 Yes/No No
A/C Pressure Disable Eng 2 Yes/No No
A/C Relay Circuit Status ODD OK/Fault/Invalid State OK
A/C Relay Command Eng 1, 2, EGR, Misfire On/Off Off
A/C Request Signal Eng 2 Yes/No No
Air Fuel Ratio Eng 2, Fuel Trim Ratio 14.2:1-14.7:1
BARO Eng 1, EGR, EVAP, Fuel Trim kPa 65-110 kPa
CMP Sensor Signal Present Eng 2 Yes/No Yes
Crank Request Signal Eng 2 Yes/No No
Cruise Control Active Eng 1 Yes/No No
Cruise Inhibit Reason Eng 1 Varies Vehicle Speed
Cruise Inhibit Signal Circuit Status ODD OK/Stuck Low (open)/Stuck High/Fault OK
Cruise Inhibit Signal Command Eng 1 On/Off On
Current Gear Eng 1, Eng 2, EGR, Fuel Trim Transmission Gear Position 1
Cycles of Misfire Data Misfire Counts 0-99
Cyl. 1-6 Injector Circuit History ODD OK/Stuck Low/Open/Stuck High/Fault OK
Cyl. 1-6 Injector Circuit Status ODD OK/Stuck Low (open)/Stuck High OK
Decel. Fuel Cutoff EGR, Fuel Trim Active/Inactive Inactive
Desired EGR Position Eng 1, EGR, Misfire Percent 0
Desired EGR Position EGR Volts 0
Desired Idle Speed Eng 1, 2, EVAP RPM PCM Controlled (varies)
Driver Module 1 Status ODD Enabled/Off-High Volts/Off High Temp/Invalid State Enabled
Driver Module 2 Status ODD Enabled/Off-High Volts/Off High Temp/Invalid State Enabled
Driver Module 3 Status ODD Enabled/Off-High Volts/Off High Temp/Invalid State Enabled
Driver Module 4 Status ODD Enabled/Off-High Volts/Off High Temp/Invalid State Enabled
ECT Sensor Eng 1, 2, EGR, EVAP, Misfire, Fuel Trim °C/°F Varies
EGR Flow Test Count EGR Counts 0-10
EGR Learned Minimum Position EGR Volts 0.14-1.0
EGR Position Sensor Eng 1, EGR, Misfire Percent Varies
EGR Position Sensor EGR Volts 0
EGR Position Variance EGR Percent 0-9
EGR Solenoid Circuit History ODD OK/Fault OK
EGR Solenoid Circuit Status ODD OK/Off-High Volts/Off High Temp/Invalid State OK
EGR Solenoid Command EGR Percent 0
Engine Load Eng 1, 2, Misfire, Fuel Trim, EVAP, EGR Percent 2-5
Engine Oil Level Switch Eng 2 OK/Low OK
Engine Oil Life Remaining Eng 2 Percent 0-100% (varies)
Engine Run Time Engine 1, 2, EVAP, Misfire, Fuel Trim, EGR Hr: Min: Sec Varies
Engine Speed Eng 1, 2, EGR, EVAP, Misfire, Fuel Trim RPM Varies
EVAP Fault History EVAP No Fault/Excess Vacuum/Purge Valve Leak/Small Leak/Weak Vacuum No Fault
EVAP Purge Solenoid Circuit Status ODD OK/Fault/Invalid State OK
EVAP Purge Solenoid Command Eng 1, EVAP, Fuel Trim % Varies
EVAP Vent Solenoid Circuit Status ODD OK/Fault/Invalid State OK
EVAP Vent Solenoid Command Eng 1, EVAP, Fuel Trim Venting/Not Venting Venting
Extended Travel Brake Pedal Switch Eng 2 Engaged/Released Released
FC Relay 1 Circuit Status ODD OK/Fault/Invalid State OK
FC Relay 1 Command Eng 2 On/Off Off
FC Relay 2 and 3 Circuit Status ODD OK/Fault/Invalid State OK
FC Relay 2 and 3 Command Eng 2 On/Off Off
Fuel Pump Relay Circuit History Status ODD OK/Fault OK
Fuel Pump Relay Circuit Status ODD OK/Fault/Invalid State OK
Fuel Pump Relay Command Eng 1 On/Off On
Fuel Tank Level Remaining EVAP Percent 0-100
Fuel Tank Pressure Sensor Eng 1, EVAP mm Hg/in H2O Varies
Fuel Tank Pressure Sensor EVAP Volts Varies
Fuel Trim Cell EVAP, Eng 1, Fuel Trim 0-4 0
Fuel Trim Learn Eng 1, EVAP, Fuel Trim Enabled/Disabled Varies
GEN F-Terminal Signal Eng 2 Percent Varies
GEN L-Terminal Signal Command Eng 2 On/Off On
HO2S 1 EVAP, Eng 1, Fuel Trim millivolts 0-1000 and Varying
HO2S 2 Eng 1, Fuel Trim millivolts 0-1000 and Varying
IAC Position Eng 1, EGR, Fuel Trim Counts 10-40
IAT Sensor Eng 1, 2, EVAP, EGR, Fuel Trim °C/°F Varies
Ignition 1 Signal EVAP, Eng 1, EGR, Fuel Trim Volts Varies
Ignition Mode Eng 2 IC/Bypass IC
IMS Eng 1 Park/Reverse/Neutral/Drive 4/Drive 3/Drive 2/Drive 1 Varies
Injector PWM Eng 2, Fuel Trim, Misfire ms Varies (1.5-3.5)
Knock Retard Eng 1, EGR Degrees 0
Long Term FT Eng 1, 2, EVAP, Fuel Trim Percent -10% to +10%
Loop Status Eng 1, 2, Fuel Trim, EVAP, EGR Open/Closed Closed
MAF Sensor Eng 1, 2, EGR, Misfire, EVAP, Fuel Trim g/s 3-6 A/C OFF, 7.02 A/C ON (depends on altitude)
MAF Sensor Eng 2 Hz 1,200-3,000 (depends on altitude)
MAP Sensor Eng 1, 2 kPa/Volts 20-48 kPa/0.75-2 Volts (depends on altitude)
MAP Sensor EVAP, Fuel Trim, EGR, Misfire kPa 20-48 kPa (depends on altitude)
MIL Circuit Status ODD OK/Fault/Invalid State OK
MIL Command Eng 2 On/Off Off
Misfire Current Cyl. 1-6 Misfire Counts 0-4
Misfire History Cyl. 1-6 Misfire Counts 0
Number of DTCs Eng 1, EVAP, Fuel Trim Numeric Value 0
PCM / VCM in VTD Fail Enable Eng 1 Yes/No No
Power Enrichment Eng 2, Misfire, Active/Inactive Inactive
Short Term FT Eng 1, 2, EVAP, Fuel Trim Percent -10 to +10
Spark Eng 1, 2, Misfire, Fuel Trim Degrees -20 (varies)
Starter Enable Relay Circuit Status ODD OK/Fault/Invalid State OK
Starter Relay Command Eng 2 On/Off Off
Start Up ECT EVAP, Fuel Trim °C/°F Varies
Start Up IAT EVAP, Fuel Trim °C/°F Varies
TCC Brake Pedal Switch Eng 1, 2 Applied/Released Released
TCC PWM Solenoid Command Eng 2 On/Off Off
TCS Circuit History ODD OK/Fault OK
TCS Circuit Status ODD OK/Fault OK
TP Sensor Eng 1, 2, EGR, Fuel Trim, EVAP, Misfire Percent 1-4
TP Sensor Eng 1, 2 Volts 0.5-1.2
Traction Control Status (If Equipped) Eng 2 Active/Inactive Inactive
Torque Request Signal (If Equipped) Eng 2 Percent 100%
Torque Delivered Signal (If Equipped) Eng 2 Percent 70%
Vehicle Speed Sensor Eng 1, 2, EGR, EVAP, Fuel Trim, Misfire mph/km/h 0
VTD Auto. Learn Timer Eng 1 Active/Inactive Inactive
VTD Fuel Disable Eng 1 Active/Inactive Inactive
VTD Fuel Disable Until Ign. OFF Eng 1 Yes/No No