LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Impala LS >> Repair and Diagnosis >> Brakes >> Antilock Brake System And Traction Control System >> Repair Instructions >> Traction Control Switch Replacement (Monte Carlo) >> Installation Procedure

Installation Procedure

  1. Install the traction control switch to the floor console trim plate.
    2. Fig 1: Installing Traction Control Switch To Floor Console Trim Plate (Monte Carlo)
    GM578676Courtesy of GENERAL MOTORS CORP.
  2. Connect the electrical connector to the traction control switch.
  3. Carefully install the floor console trim plate. Make sure all of the retainers are fully engaged.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the floor console trim plate screw (1).

    Tighten:  Tighten the floor console trim plate screw to 2 N.m (18 lb in).

    5. Fig 2: Locating Front Floor Console Trim Plate Screw (Monte Carlo)
    GM578742Courtesy of GENERAL MOTORS CORP.
  5. Position the transaxle shift control lever to Park.
  6. Install the center console mat.
  7. Release the park brake.
scientia non olet · About LEMON Manuals