LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Impala LS >> Repair and Diagnosis >> Brakes >> Antilock Brake System And Traction Control System >> Repair Instructions >> Traction Control Switch Replacement (Impala) >> Removal Procedure

Removal Procedure

  1. If equipped with column shift, apply the parking brake.
  2. If equipped with column shift, position the transaxle shift control indicator to 1.
  3. Adjust the steering wheel for access.
  4. Remove the ignition switch cylinder bezel.
  5. Remove the LH instrument panel (IP) fuse block access opening cover.
  6. Remove the LH IP cluster trim plate screws.
  7. Remove the IP cluster trim plate for access. Start at the left side of the IP cluster trim plate, grasp the trim plate and carefully pull rearward. Disengage enough IP cluster trim plate retainers in order to gain access the traction control switch.
  8. Disconnect the electrical connector (1) from the traction control switch (2).
    9. Fig 1: Disconnecting Traction Control Switch Electrical Connector (Impala)
    GM814203Courtesy of GENERAL MOTORS CORP.
  9. Remove the traction control switch (1) from the IP cluster trim plate (2).
    10. Fig 2: Removing Traction Control Switch From Cluster Trim Plate (Impala)
    GM814200Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals