LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Impala LS >> Repair and Diagnosis >> Brakes >> Antilock Brake System And Traction Control System >> Diagnostic Information and Procedures >> DTC C1237 >> Test Description

Test Description

  1. 2:  Use the scan tool in order to inspect the voltage to the EBCM.
  2. 3:  Use the scan tool in order to inspect the voltage to the body control module. A high voltage value in multiple modules indicates a concern in the charging system.
  3. 4:  Verifies that the condition is still present.
DTC C1237

Step Action Value(s) Yes No
Schematic Reference:  ABS Schematics  
1 Did you perform the ABS Diagnostic System Check? - Go to Step 2  Go to Diagnostic System Check - ABS 
2 
  1. Turn OFF all of the accessories.
  2. Install a scan tool.
  3. Start the engine.
  4. Run the engine at approximately 2000 RPM.
  5. With a scan tool, observe the Switched Battery Voltage parameter in ABS data list.
Does the scan tool indicate that the voltage is greater than the specified value?		 16.3 V Go to Step 3  Go to Diagnostic Aids
3  With a scan tool, observe the Electronics Battery Fd parameter in the Body Control Module data list.
Does the scan tool indicate the voltage is greater than the specified value?		 16.3 V Go to Diagnostic System Check - Engine Electrical in Engine Electrical Go to Step 4 
4 
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.
Does the DTC reset?		 - Go to Step 5  Go to Diagnostic Aids
5 Replace the EBCM. Refer to Electronic Brake Control Module Replacement  .
Did you complete the repair?		 - Go to Step 6  -
6
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the conditions for Running the DTC as specified in the supporting test.
Does the DTC reset?		 - Go to Step 2  System OK
scientia non olet · About LEMON Manuals