LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Epica LS >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System >> Repair Instructions >> Wheel Speed Sensor Replacement - Rear >> Installation Procedure

Installation Procedure

    Fig 1: View Of Rear Hub Unit
    GM1255825Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The wheel speed sensor is served as an assembly, hub-wheel speed sensor. Therefore, the additional working procedure for air gap is not needed.
  1. Install the rear hub unit. Refer to Wheel Bearing/Hub Replacement - Rear in Rear Suspension.
  2. Connect the rear wheel speed sensor electrical connector.
  3. Lower the vehicle.
  4. Connect the negative battery cable.
scientia non olet · About LEMON Manuals